Features:

    Integral Sump with in-built water level control sensor

    Pump Head of 6 metres

    Will move up to 6 Litres / Hour

    Suction lift up to 2 metres (max)

    Will remove up to 35,000 btu/hr (sensible cooling) condensate 

       water from air conditioners

    Built in non-return valve

    Can be installed in wall, ceiling and floor mounted split systems.

Installation Guide:

    The pump units are intended to be screw fixed within a ceiling 

       void, but may be installed surface mounted if no ceiling void 

       exists  in PVC trunking.

    The Standard model pump, sump and suction tube can be 

       concealed within 100 mm x 50 mm PVC trunking.

    It may be possible with certain units to conceal the sump in the   

       fan coil.  When mounting the sump integrally the engineer may 

       need to fit a `Terrain Tank Connector' (not supplied) into the side 

       of the sump (see figures 2 & 3).

    To do this drill a 22 mm hole into an appropriate place in the 

       sump  and use a suitable fitting.

    The pump is self priming, although the pump lift should be kept to 

       a minimum (2 metres or less) to reduce pump noise.

    It should be noted that on initial start up, the pump may be noisy 

       for a few seconds until the pump is primed.

    The pump has a non-return valve incorporated to prevent `water 

       run back`.

For Electrical Information, please click above.

Figure 1:  Pump in ceiling void

Figure 2:  Sump with tank connector fitting

Figure 3:  Ceiling Suspended Application

For More Information Contact:

Airtech Ltd
Devon House, Eastbourne Road, Blindley Heath, Surrey, RH7 6JJ.
Tel: 01342 836000
FAX: 01342 835930
Internet: ac@airtech.uk.com

[ Home ] [ Up ] [ Little Squirt Electrical Information ]

Copyright © 1999 Airtech Air Conditioning
Last modified: May 08, 2005