Home Up Contents Feedback Price List Distributors List Links

ASP Freestyle Condensate Pump Kit

 

 

 


Features:

    Integral Sump with in-built water level control sensor

    Pump Head of 8 metres

    Will move up to 8 Litres / Hour

    Suction lift up to 2 metres (max)

    Will remove up to 45,000 btu/hr (sensible cooling) condensate 

       water from air conditioners

    Built in non-return valve

    Can be installed in wall, ceiling and floor mounted split systems.

    Comes in component form to enable installers free to explore

       installation methods not always possible with the standard model.


Installation Guide:

   Select a location for the pump unit and sump - bear in mind the 

      intended refrigeration pipe routes, power cables, control wiring and 

      isolators when doing this.

   Mount the pump adjacent to, or depending on the model in the 

      appropriate size of trunking. 

   The suction tube and sump should then be located approximately 

      100 mm below the baseline of the fan coil (refer to figure 1 

      below).

    It is good practise to insulate the suction tube as this prevents 

      "sweating" and "buzz" (caused by the pump tubing vibrating against 

       the trunking).   

    The fan coils condensate discharge pipe should be routed into the   

       sump box.  It is suggested that the pipe be arranged in such a way 

       they there is an air gap between the discharge and the high water 

       level in the sump.  This prevents water being siphoned back into 

       the fan coil.  This can occur on high fan speed or when the filters 

       are dirty.

    A length of 1/4" drain tube (not supplied) should be connected to 

      the discharge side of the pump unit and run to the waste point 

      (outside drain).

    Ideally the tube should be insulated if it is to run through humid

       areas, or externally where the risk of freezing could occur.

 

                                             

For Electrical Information, please click above.

 


Figure 1:  Pump in ceiling void

 


Figure 2:  Sump with tank connector fitting

         


Figure 3:  Ceiling Suspended Application


For More Information Contact:

Airtech Ltd
Devon House, Eastbourne Road, Blindley Heath, Surrey, RH7 6JJ.
Tel: 01342 836000
FAX: 01342 835930
Internet: ac@airtech.uk.com

 

Home ] Up ] Freestyle Pump Electrical Information ]

Copyright © 1999 Airtech Air Conditioning
Last modified: May 08, 2005