Mount external condensing units simply and easily using Airtech Special Products Wall Adjustable Brackets. The condensing units can be mounted above or below the bracket simply by placing the strengthening rib at the top or bottom when being installed (see installation - fixing notes), making them suitable for a wide range of installation conditions.

Brackets can be utilised for virtually all condensing unit models and brand names including application for Fujitsu, Toshiba, Mitsubishi, Daikin, Hitachi etc.

The bracket is a sturdy 40 mm x 40 mm x 5 mm steel angle welded construction with a reinforcing rib for extra strength. These brackets when correctly fitted will carry a load of 200 Kg (see note on fixings).

All brackets are finished in a durable grey/silver hammer finish.

The condensing unit brackets (shown below) are easily fixed using the M10* hilti bolts which fit through the pre-drilled holes in the vertical leg of  the bracket. There are pre-drilled holes in the front leg of the horizontal legs of the brackets requiring only the back holes to be drilled for securing the condenser.  Alternatively the engineer can choose to drill four new holes to suit the particular unit being installed.  4 No. M8 set screws, rubber washers, M8 nylon lock nuts with M8 washers are provided for bolting the condensing unit to the brackets.

Wall Fixings:                                         Bracket Fixings:

                                                                 4 No.M10 Serrated Units

4 No. M8 x 30 mm Set Screws                  4 No. Rubber Washers

8 No. M8 Washers                                    4 No. M8 Nylon Lock Nuts

Fixings Note * :

*  The M10 Hilti bolts that are supplied will suit most applications when used in solid masonry.  However in soft brickwork or poor quality walling it is the responsibility of the installing engineer to determine the appropriate fixing to be used as specific performance data cannot be assured owing to the diversity of these materials.